FT5004: Heatsink/Purge Fitting, 68 - 74 mm T47/PF30 BB Shells

Product Details

• Application:
  • Heatsink and purge fitting
  • 68 - 74 mm T47 and PF30 bottom bracket shells
  • Introduces argon into the frame and absorbs heat from the weld to reduce distortion; results vary based on tubing diameters, wall thicknesses, and personal welding styles.
• Compatibility:
  
  • Specifically sized to fit our shells with a 1.860" center relief
  • Metal to metal interfaces are bronze to stainless steel making sticking, binding or galling very unlikely
  • If you already own one of our heatsinks for a T47 or PF30 bottom bracket shell, you only need to buy the bronze center, FT5014, and draw bolt, FT5022; the rest of the pieces in the assembly are interchangeable.
• Components:
  • Center: C-630 bronze (very good heat conductor)
  • Cones: 303 stainless steel
    • The center expands with two cones to fit with minimal clearance on the interior diameter of the bottom bracket shell. One cone butts against the draw bolt and the other is threaded female 1/4" NPT for the argon connection
  • Draw Bolt: C-630 bronze
    • Drilled to accept argon from the threaded cone. It has an internal hexagon to accept both a 5/16" and 8 mm Allen wrench
  • Washers: 
    • Two 1-7/8" OD stainless steel washers plug both ends of the bottom bracket shell and are pulled together with two M20 x 1.5 nuts.

Item sold as an 8 piece assembly.

Directions for Use

1. After the frame has been tacked, remove from the fixture.
2. Insert the bronze expanding sleeve into the bottom bracket shell. The sleeve must be compressed slightly to get it in the shell.
3. Place both cones in the sleeve.
4. Insert bronze draw bolt through one cone and thread it into the cone on the opposite side.
5. Using the 8 mm internal hexagon in the bolt, tighten the bolt which will expand the sleeve.
6. Install both washers with the mating nuts.
7. Introduce Argon through the connector (not included; the connector fits inside a standard 1/4" internal pipe thread in the cone).
8. To remove the heatsink, reverse the above procedure.